AZ Series EtherNet /IP™ Compatible Drivers FAQ
This is an excerpt of some common questions related to the AZ Series EtherNet/IP™ driver profile taken from the FAQ section of the Oriental Motor website. Refer according to purpose.
Target Product Name
AZD-AEP, AZD-CEP, AZD-KEP, AZD-KREP
Introduction and Review
- Q545. How do I carry out multi-axis connection with the driver?
- Q546. What is the maximum number of units that can be controlled?
- Q547. Can I use standard Ethernet HUBs?
- Q548. How many ms is the communication cycle?
- Q549. With the support software for data set to MEXE02, can I connect over a LAN?
- Q550. Can the product be used in combination with other companies’ products?
- Q556. Is explicit communication supported?
- Q557. I would like to control (socket communication) with a PC. How do I do this?
- Q566. The number of connections listed in the implicit communication specifications is "2." What does this mean?
Establishing Connection and Communication
Usage and Utilization
- Q552. The fixed I/O SET-ERR signal is ON. What kind of signal is SET-ERR?
- Q553. Can the travel amount be set with mm or deg?
- Q554. What kind of input signal is the fixed I/O TRIG-MODE?
- Q559. Operation data was written via communication, but the data prior to writing was returned due to turning the power off and back on.
Is data written via communication not saved? - Q560. I would like to change the description for assignable monitor. How do I do this?
- Q561. I would like to monitor the detection position. How do I do this?
- Q562. How can I perform return-to-home?
- Q563. If the data is changed and the ON setting for TRIG are sent in the same single frame in direct data operation, is the data change applied?
- Q565. I would like to execute a maintenance command. How do I do this?