Q.I am using AZ Series EtherNet/IP compatible driver. I would like to change the optional monitor content. How do I do this?
Change the setting value of "Assignable Monitor 0~3" using the support software MEXE02 or EtherNet/IP communication.
As an example, the procedure for changing the monitor contents of "Assignable Monitor 0" to "Main Power Supply Time" using the support software MEXE02 is introduced.
-
Confirm the parameter ID of the content you would like to monitor from the User Manual
.
-
Set the parameter ID of the content you would like to monitor to the "Assignable Monitor 0" parameter in the "Communication and I/F Functions" of MEXE02.
-
Execute the "Write Data" command.
If you are configuring the settings via EtherNet/IP communication, use the following addresses for the settings.
| Parameter ID | Name | |
|---|---|---|
| Dec | Hex | |
| 25600 | 6400h | Optional monitor address 0 |
| 25601 | 6401h | Assignable monitor 1 |
| 25602 | 6402h | Assignable monitor 2 |
| 25603 | 6403h | Assignable monitor 3 |
Related Information: AZ Series EtherNet/IP TM Compatible Driver FAQ
Product Category: αSTEP, electric actuators
Model and Series: AZ Series, electric actuator AZ Series equipped
Description: How to Use/Setting Method
FAQ No.: 560
Related FAQs
Email to Technical Support
After opening the email, we will check the contents and contact you. Please note that depending on the nature of your enquiry, we may contact you by phone.